This dump is 100% valid to pass IBM P2060-017 exam. The only tips is please do not just memorize the questions and answers, you need to get through understanding of it because the question changed a little in the real exam. Follow the instructions in the CertBus P2060-017 IBM B2B Integration SaaS Technical Mastery Test v1 PDF and VCEs. All CertBus materials will help you pass your IBM exam successfully.
We CertBus has our own expert team. They selected and published the latest P2060-017 preparation materials from IBM Official Exam-Center: http://www.certgod.com/P2060-017.html
QUESTION NO: 153
What is necessary to install and configure IVM to use the network interface?
A. SSH Key Manager
B. A serial connection
C. The IBM HTTP Server
D. A private IP address
Correct Answer: B
QUESTION NO: 45
A retail customer installs a BladeCenter into an existing 10/100 Ethernet network. Due to cost
considerations, the customer uses Copper Passthru Modules. After installing this solution, the
customer finds that they have no network connectivity. Which of the following at is causing the
problem?
A. CopperPassthru Modules only support 1000Mb line speeds.
B. Spanning Tree has been enabled on the CopperPassthru Module.
C. The customer does not have the latest firmware loaded on the CopperPassthru Module.
D. The customer is using LS21 Blades
Answer: A
QUESTION NO: 72
A Resource pool defines two slots, 9-12 and 1-5, and the available capacity is four hours in each
slot. The following capacity reservations are to be made:
In IBM Sterling Selling and Fulfillment Suite, which capacity reservations will be created?
A. Res1
B. Res2
C. Res3
D. Res4
Answer: A
Explanation:
QUESTION NO: 102
Which command restores a backup of system state?
A. restore syssta
B. restore system
C. restore sysstate
D. restore systemstate
Answer: D
QUESTION NO: 35
A systems service processor is being connected to a redundant HMC. Which of the following is required to
support DHCP server on dual HMCs?
A. The two HMCs must be on different subnets.
B. The redundant HMC must have the \’Redundant DHCP Range\’ check box selected on ethernet ent0
configuration.
C. Both HMCs must be running RMC on a shared private network.
D. The first HMC must be set as primary DHCP range.
Correct Answer: A
