Do not worry about that if you are stuck in the CCDE 352-001 exam difficulties, CertBus will assist you all your way through the CCDE 352-001 ADVDESIGN exam with the most update CCDE 352-001 PDF and VCE dumps. CertBus exam 352-001 preparation materials are the most comprehensive material, covering every key knowledge of 352-001 ADVDESIGN exam.
We CertBus has our own expert team. They selected and published the latest 352-001 preparation materials from Cisco Official Exam-Center: http://www.certgod.com/352-001.html
QUESTION NO:14 You are designing a network that will run EIGRP over a Metro Ethernet service that does not employ a link-loss technology. What will be the impact on convergence if there is a break in the end-to-end Layer 2 connectivity within the service provider network?
A. The routers will immediately lose their adjacencies and converge.
B. The routing protocol will not converge until the hold timers have expired.
C. The switch ports connected to the router will go down and the routers will immediately converge.
D. The VLAN on the switches will go inactive, the ports associated on the switch will go down, and the routers will immediately converge.
Answer: B
QUESTION NO:1 A company plans to include Nonstop Forwarding and Bidirectional Forwarding Detection as a part of their network redundancy plan. In which two ways do NSF and BFD work together when different hardware platforms are compared? (Choose two.)
A. During supervisor engine or routing engine failover, the NSF feature will always ensure that the BFD at the peer router will not trigger a link down independent of the used hardware platform.
B. At some hardware platforms, BFD and NSF are not supported together. During supervisor engine or routing engine failover, the BFD at the peer router will trigger a link down.
C. To ensure that BFD at the peer router will not trigger a link down during NSF, the BFD packets must be processed fast enough, and, during supervisor engine or routing engine failover, by processing the BFD independent from the supervisor engine or routing engine.
D. Because BFD is always processed at the line cards (not at the supervisor engine or routing engine), a supervisor engine or routing engine failover will not affect the BFD peer router.
E. Because BFD is always processed at the supervisor engine or routing engine, a supervisor engine or routing engine failover will always trigger a link down at the peer router.
Answer: B, C
QUESTION NO:16 A new video multicast application is deployed in the network. The application team wants to use the 239.0.0.1 multicast group to stream the video to users. They want to know if this choice will impact the existing multicast design. What impact will their choice have on the existing multicast design?
A. Because 239.0.0.1 is a private multicast range, a flood of PIM packets that have to be processed by the CPU and hostswill be sent by the routers in the network.
B. Because 239.0.0.1 is a private multicast range, the rendezvous point has to send out constant group updates that will have to be processed by the CPU and hosts.
C. The multicast application sends too many packets into the network and the network infrastructure drops packets.
D. The 239.0.0.1 group address maps to a system MAC address, and all multicast traffic will have to be sent to the CPU and flooded out all ports.
Answer: D
QUESTION NO:5 Refer to the exhibit.
You are designing a spanning-tree network for a small campus. Which two of these options would result in a trouble-free spanning-tree network design? (Choose two.)
A. Convert all ports to trunk ports, prune off the VLANs that you do not require, and minimize the number of blocking ports.
B. Introduce Layer 3 VLANs (SVIs) and prune off the VLANs that you do not require.
C. Convert all the ports to trunk and enable BackboneFast.
D. Convert all the ports to trunk and enable UplinkFast between all the links.
Answer: A, B
QUESTION NO:4 A network designer is working with a company to improve convergence at the Layer 2 control plane and decides to use LACP. Which of these components does LACP use to create the system ID?
A. LACP system priority and switch MAC address
B. LACP port priority and switch MAC address
C. LACP port priority and port number
D. LACP system priority and port number
Answer: A
QUESTION NO:12 Voice traffic between two campus enterprise networks is growing. The network designers decide to add a second 10-Mb Metro Ethernet service parallel to their original 10-Mb service in order to provide more bandwidth and diversity. The QoS profile will be the same on the new 10-Mb service due to the voice stability on the first Metro Ethernet link. When the second link is added to the OSPF domain, which traffic design consideration would have the most impact on the voice traffic when both links are active?
A. per-destination IP address basis
B. per-flow basis
C. per-packet basis
D. per-source IP address basis
Answer: C
QUESTION NO:2 Refer to the exhibit.
A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)
A. Enable Y.1731 Connectivity Fault Management on the SP switches.
B. E-LMI PDUs must be forwarded over VPLS.
C. Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
D. Use upward maintenance endpoints on the SP switches.
E. Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.
Answer: D, E
QUESTION NO:26 During a network design review, it is recommended that the network with a single large area should be broken up into a backbone and multiple nonbackbone areas. There are differing opinions on how many ABRs are needed for each area for redundancy. What would be the impact of having additional ABRs per area?
A. There is no impact to increasing the number of ABRs.
B. The SPF calculations are more complex.
C. The number of externals and network summaries are increased.
D. The size of the FIB is increased.
Answer: C
QUESTION NO:27 A large enterprise customer is migrating thousands of retail offices from legacy TDM circuits to an Ethernet-based service. The network is running OSPF and has been stable for many years. It is now possible to backhaul the circuits directly to the data centers, bypassing the regional aggregation routers. Which two networking issues need to be addressed to ensure stability with the new design? (Choose two.)
A. Nothing will change if the number of offices is the same.
B. Nothing will change if the number of physical interfaces stays the same.
C. The RIB will increase significantly.
D. The FIB will increase significantly.
E. The amount of LSA flooding will increase significantly.
F. The size of the link-state database will increase significantly.
Answer: E, F
The design is being proposed for use within the network. The CE devices are OSPF graceful restart-capable, and the core devices are OSPF graceful restart-aware. The WAN advertisements received from BGP are redistributed into OSPF. A forwarding supervisor failure event takes place on CE A. During this event, how will the routes learned from the WAN be seen on the core devices?
A. via CE A and CE B
B. via CE A
C. via CE B
D. no WAN routes will be accessible
Answer: C
QUESTION NO:17 A customer is using a service provider to provide a WAN backbone for a 30-site network. In establishing the network, the customer must work within these constraints:
–
The customer has a self-managed MPLS backbone.
–
The VPLS WAN backbone of the service provider does not support PIM snooping.
–
Multicast VPN must be used for multicast support inside some VRFs. What can the customer do so that multicast traffic is NOT flooded to all sites?
A.
Configure static GRE tunnels and run the MPLS and multicast VPN inside these GRE tunnels.
B.
Use Label Switched Multicast for the multicast transport.
C.
Use PIM-SSM as the multicast routing protocol with IETF Rosen Draft multicast VPN.
D.
Configure a static mapping between multicast addresses and MAC addresses.
E.
Use GET VPN to encrypt the multicast packets inside the WAN.
Answer: A
CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 352-001 exam successfully with our Cisco materials. CertBus ADVDESIGN exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus ADVDESIGN exam questions and answers are the most valid. CertBus exam ADVDESIGN exam dumps will help you to be the Cisco specialist, clear your 352-001 exam and get the final success.
352-001 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mTUFOZm5MQWgzUkE/view?usp=sharing
352-001 Cisco exam dumps (100% Pass Guaranteed) from CertBus: http://www.certgod.com/352-001.html [100% Exam Pass Guaranteed]
Why select/choose CertBus?
Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.
 |  |  |  |  | |
|---|---|---|---|---|---|
 |  | | |  | |
| Brand | Certbus | Testking | Pass4sure | Actualtests | Others |
| Price | $45.99 | $124.99 | $125.99 | $189 | $69.99-99.99 |
| Up-to-Date Dumps |  |  | | | |
| Free 365 Days Update | | | | | |
| Real Questions | | | | | |
| Printable PDF | | | | | |
| Test Engine | | | | | |
| One Time Purchase | | | | | |
| Instant Download | | | | | |
| Unlimited Install | | | | | |
| 100% Pass Guarantee | | | | | |
| 100% Money Back | | | | | |
| Secure Payment | | | | | |
| Privacy Protection | | | | | |