Do not worry about your CCIE 350-001 exam preparation? Hand over your problems to CertBus in change of the CCIE 350-001 CCIE Routing and Switching Written certifications! CertBus provides the latest Cisco CCIE 350-001 exam preparation materials with PDF and VCEs. We CertBus guarantees you passing CCIE 350-001 exam for sure.
We CertBus has our own expert team. They selected and published the latest 350-001 preparation materials from Cisco Official Exam-Center: http://www.certgod.com/350-001.html
QUESTION NO:20
Refer to the exhibit.
What is the potential issue with this configuration?
A. There is no potential issue; OSPF will work fine in any condition.
B. Sub-optimal routing may occur since there is no area 1 adjacency between the ABRs.
C. This is a wrong OSPF configuration because all routers must be in area 0 only.
D. This is a wrong OSPF configuration because /30 requires 0.0.0.3 wild card.
Answer: B
Explanation:
QUESTION NO:18
Refer to the exhibit.
Which statement is correct about the prefix 160.0.0.0/8?
A. The prefix has encountered a routing loop.
B. The prefix is an aggregate with an as-set.
C. The prefix has been aggregated twice, once in AS 100 and once in AS 200.
D. None of these statements is true.
Answer: B
Explanation:
QUESTION NO:17
Which three combinations are valid LACP configurations that will set up a channel? (Choose
three.)
A. On/On
B. On/Auto
C. Passive/Active
D. Desirable/Auto
E. Active/Active
F. Desirable/Desirable
Answer: A,C,E
Explanation:
QUESTION NO:28
Which two orders in the BGP Best Path Selection process are correct? (Choose two.)
A. Higher local preference, then lowest MED, then eBGP over iBGP paths
B. Higher local preference, then highest weight, then lowest router ID
C. Highest weight, then higher local preference, then shortest AS path
D. Lowest origin type, then higher local preference, then lowest router ID
E. Highest weight, then higher local preference, then highest MED
Answer: A,C
Explanation:
QUESTION NO:24
Refer to the exhibit.
R1 is not learning about the 172.16.10.0 subnet from the BGP neighbor R2 (209.165.202.130).
What can be done so that R1 will learn about this network?
A. Disable auto-summary on R2.
B. Configure an explicit network command for the 172.16.10.0 subnet on R2.
C. Subnet information cannot be passed between IBGP peers.
D. Disable auto-summary on R1.
Answer: B
Explanation:
By default, BGP does not accept subnets redistributed from IGP. To advertise and carry subnet
routes in BGP, use an explicit network command or the no auto-summary command. If you disable
auto-summarization and have not entered a network command, you will not advertise network
routes for networks with subnet routes unless they contain a summary route.
Reference
http://www.cisco.com/en/US/docs/ios/11_3/np1/command/reference/1rbgp.html
QUESTION NO:11
When you are troubleshooting duplex mismatches, which two errors are typically seen on the full-
duplex end? (Choose two.)
A. runts
B. FCS errors
C. interface resets
D. late collisions
Answer: A,B
Explanation:
QUESTION NO:31
How will EIGRPv6 react if there is an IPv6 subnet mask mismatch between the Global Unicast
addresses on a point-to-point link?
A. EIGRPv6 will form a neighbor relationship.
B. EIGRPv6 will not form a neighbor relationship.
C. EIGRPv6 will form a neighbor relationship, but with the log MSG: “EIGRPv6 neighbor not on a
common subnet.”
D. EIGRPv6 will form a neighbor relationship, but routes learned from that neighbor will not be
installed in the routing table.
Answer: A Explanation:
http://www.ietf.org/rfc/rfc3587.txt
QUESTION NO:19
Which two options does Cisco PfR use to control the entrance link selection with inbound
optimization? (Choose two.)
A. Prepend extra AS hops to the BGP prefix.
B. Advertise more specific BGP prefixes (longer mask).
C. Add (prepend) one or more communities to the prefix that is advertised by BGP.
D. Have BGP dampen the prefix.
Answer: A,C
Explanation: PfR Entrance Link Selection Control Techniques
The PfR BGP inbound optimization feature introduced the ability to influence inbound traffic. A
network advertises reachability of its inside prefixes to the Internet using eBGP advertisements to
its ISPs. If the same prefix is advertised to more than one ISP, then the network is multihoming.
PfR BGP inbound optimization works best with multihomed networks, but it can also be used with
a network that has multiple connections to the same ISP. To implement BGP inbound
optimization, PfR manipulates eBGP advertisements to influence the best entrance selection for
traffic bound for inside prefixes. The benefit of implementing the best entrance selection is limited
to a network that has more than one ISP connection.
To enforce an entrance link selection, PfR offers the following methods:
BGP Autonomous System Number Prepend When an entrance link goes out-of-policy (OOP) due
to delay, or in images prior to Cisco IOS Releases 15.2(1) T1 and 15.1(2)S, and PfR selects a
best entrance for an inside prefix, extra autonomous system hops are prepended one at a time (up
to a maximum of six) to the inside prefix BGP advertisement over the other entrances. In Cisco
IOS Releases 15.2(1)T1, 15.1(2)S, and later releases, when an entrance link goes out-of policy
(OOP) due to unreachable or loss reasons, and PfR selects a best entrance for an inside prefix,
six extra autonomous system hops are prepended immediately to the inside prefix BGP
advertisement over the other entrances. The extra autonomous system hops on the other
entrances increase the probability that the best entrance will be used for the inside prefix. When
the entrance link is OOP due to unreachable or loss reasons, six extra autonomous system hops
are added immediately to allow the software to quickly move the traffic away from the old entrance
link. This is the default method PfR uses to control an inside prefix, and no user configuration is
required.
BGP Autonomous System Number Community Prepend
When an entrance link goes out-of-policy (OOP) due to delay, or in images prior to Cisco IOS
Releases 15.2
(1)T1 and 15.1(2)S, and PfR selects a best entrance for an inside prefix, a BGP prepend
community is attached one at a time (up to a maximum of six) to the inside prefix BGP
advertisement from the network to another autonomous system such as an ISP. In Cisco IOS
Releases 15.2(1)T1, 15.1(2)S, and later releases, when an entrance link goes out-of-policy (OOP)
due to unreachable or loss reasons, and PfR selects a best entrance for an inside prefix, six BGP
prepend communities are attached to the inside prefix BGP advertisement. The BGP prepend
community will increase the number of autonomous system hops in the advertisement of the
inside prefix from the ISP to its peers. Autonomous system prepend BGP community is the
preferred method to be used for PfR BGP inbound optimization because there is no risk of the
local ISP filtering the extra autonomous system hops. There are some issues, for example, not all
ISPs support the BGP prepend community, ISP policies may ignore or modify the autonomous
system hops, and a transit ISP may filter the autonomous system path. If you use this method of
inbound optimization and a change is made to an autonomous system, you must issue an
outbound reconfiguration using the “clear ip bgp” command.
Reference
http://www.cisco.com/en/US/docs/ios-xml/ios/pfr/configuration/15-2s/pfr-bgp-inbound.html#GUID-
F8A59E241D59-
4924-827D-B23B43D9A8E0
http://www.cisco.com/en/US/products/ps8787/products_ios_protocol_option_home.html
QUESTION NO:23
What action will a BGP route reflector take when it receives a prefix marked with the community
attribute NO ADVERTISE from a client peer?
A. It will advertise the prefix to all other client peers and non-client peers.
B. It will not advertise the prefix to EBGP peers.
C. It will only advertise the prefix to all other IBGP peers.
D. It will not advertise the prefix to any peers.
Answer: D
Explanation:
QUESTION NO:3
A new backup connection is being deployed on a remote site router. The stability of the connection
has been a concern. In order to provide more information to EIGRP regarding this interface, you
wish to incorporate the “reliability” cost metric in the EIGRP calculation with the command metric
weights 1 0 1 0 1.
What impact will this modification on the remote site router have for other existing EIGRP
neighborships from the same EIGRP domain?
A. Existing neighbors will immediately begin using the new metric.
B. Existing neighbors will use the new metric after clearing the EIGRP neighbors.
C. Existing neighbors will resync, maintaining the neighbor relationship.
D. All existing neighbor relationships will go down.
Answer: D
Explanation:
CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 350-001 exam successfully with our Cisco materials. CertBus CCIE Routing and Switching Written exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus CCIE Routing and Switching Written exam questions and answers are the most valid. CertBus exam CCIE Routing and Switching Written exam dumps will help you to be the Cisco specialist, clear your 350-001 exam and get the final success.
350-001 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mUVBtM1piOS1IMEU/view?usp=sharing
350-001 Cisco exam dumps (100% Pass Guaranteed) from CertBus: http://www.certgod.com/350-001.html [100% Exam Pass Guaranteed]
Why select/choose CertBus?
Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.